3.035 Heart rates and blood pressure

Heart rates

A person's pulse rate is normally given as a number of beats per minute. However, when measuring someone's pulse, a medical practitioner usually does not want to count the number of heart beats over a full minute.

Instead, it is more convenient to count the number of beats in a shorter time, say, $15$15 seconds and then to use this number to predict how many beats there would be in a full minute.

Thus, if $14$14 beats were counted in a period of $15$15 seconds, we would argue that since there are $4$4 lots of $15$15 seconds in a minute we must multiply the $14$14 by $4$4 and get $56$56, the number of beats that would occur per minute.

Another approach would be to measure with a stopwatch the time taken for a fixed number of heart beats, say $10$10, and to use this time measurement to work out the rate per minute. This is illustrated in the following example.

 

Exploration

After some physical exertion, a person's heart was found to beat $10$10 times in $4.5$4.5 seconds. What is their heart rate in beats per minute?

Method 1:
Ask how many periods of $4.5$4.5 seconds are there in $60$60 seconds. The number of beats per minute will be $10$10 times this number. So, we calculate $\frac{60}{4.5}\times10=133$604.5​×10=133 beats per minute.

Method 2:
Ask how many beats there would be in $1$1 second, or in this case, what fraction of a beat would there be in $1$1 second. The number of beats per minute will be $60$60 times this number. We calculate $\frac{10}{4.5}\times60=133$104.5​×60=133, as before.

You should notice that the calculation contains the same steps in both methods. The difference is in the way the problem is conceptualised.

 

Blood pressure

Blood pressure is the ratio of two pressure measurements written in the form of a fraction. The two measurements of pressure involved are called the systolic and the diastolic pressures. They correspond respectively to the pressures at and between heartbeats.

$\text{blood pressure}=\frac{\text{systolic pressure}}{\text{diastolic pressure}}$blood pressure=systolic pressurediastolic pressure​

However, unlike other ratios, we do not normally simplify the blood pressure ratio down to lowest terms because the actual systolic and diastolic measurements are each important and these would be lost if any cancelling down occurred in the fraction.

Pressures are measured in millimetres of mercury (mm.Hg) in the medical context because of a historical method of measuring pressure in terms of the height of a column of mercury the pressure would support. In physics, the pressure is defined as force per unit area so that a pressure of $1$1 pascal is equal to a force of $1$1 Newton per square metre. Several other units of pressure measurement are currently used for various purposes.

So the pressure is a rate - force per unit area - but blood pressure is, roughly speaking, a ratio formed by two rates - the systolic and diastolic pressures.

 

Practice questions

Question 1

Question 2

Question 3